JTB XClipClean Trial
JTB World Inc.JTB XClipClean Trial
JTB World Inc.JTB XClipClean is an Xclip-cutter app for Autodesk® AutoCAD® to clean up xrefs or blocks that have been clipped so that the information that is outside the clip is removed.
Trial
JTB XClipClean is an Xclip-cutter app for Autodesk® AutoCAD® to clean up xrefs or blocks that have been clipped so that the information that is outside the clip is removed. This is useful when you need to remove hidden geometry and minimize DWG file size.
AutoCAD allows blocks and xrefs to be clipped using the XCLIP command. Sometimes for different reasons, you have to clean up the blocks or xrefs that have been clipped. JTB XClipClean can help you with that by deleting and trimming geometry that is outside the clip boundary.
Autodesk® Revit® does not handle xclipped blocks and xrefs so JTB XClipClean can be useful to run on drawings before taking them into Revit.
This app has a custom installer. Elevated user privileges are required to install this product.
For further information and documentation visit JTB World's XClipClean page.
Note: This app uses a custom installer (and not the standard App Store installer).
Details
Operating system
Release date
Aug 13, 2020
Last updated
Mar 16, 2026
Version
5.1.0
Language
Compatible with
ACD
2021, 2022, 2023, 2024, 2025, 2026
MAP
2021, 2022, 2023, 2024, 2025, 2026
CIV3D
2021, 2022, 2023, 2024, 2025, 2026
ACAD_E
2021, 2022, 2023, 2024, 2025, 2026
ADSTPR
2021, 2022, 2023, 2024, 2025, 2026
BLDSYS
2021, 2022, 2023, 2024, 2025, 2026
Certifications
Digitally signed
Capabilities
MEP
Building design
Blocks
Structural design
Interoperability
Tags
Scheduling
Frequently asked questions (FAQs)
What else should I know about this product?
Support for AutoCAD 2017 and older is available by contacting JTB World directly.
Are there any known issues with this product?
XClipClean was built to solve some specific requirements and thus there are cases where XClipClean does not work well or at all. Nested clipped blocks are not handled. Inverted clipped blocks are not handled. It might be possible to modify the code to handle these cases but the work might be more than the gain.
Hatch trimming is not supported.
SDI set to 1 is not supported. SDI must be set to 0.
The HIGHLIGHT variable may be set to 0 if the app fails and you need to restore it to 1 manually.
Is there additional support information provided?
For further information and documentation visit JTB World's XClipClean page.
Found an issue?