This command can be used to SET the Surface and Alignment that a Pressure Fitting part references.

The Pressure Fitting part is a crucial component in Autodesk® Civil 3D®. When dealing with a large number of pressure fittings, it's important to note that creating a Pressure network without defining its alignment or surface reference will result in each Pressure Fitting lacking these references.

To display information about a Pressure Fitting correctly, you need to define its alignment and surface references. Additionally, these references can be updated if needed.

Therefore, a single command that allows setting both the Surface and Alignment that the Pressure Fitting part references is desirable, eliminating the need to repeat the command.

This is also possible with an alternative command.