AG MEP 3D Router
BIM MinutesAG MEP 3D Router
BIM MinutesAG MEP 3D Router lets you route pipes, ducts, conduits and cable trays directly in a Autodesk® Revit® 3D view.
Free
AG MEP 3D Router lets you route pipes, ducts, conduits and cable trays directly in a Revit 3D view. Click the open end of a run and a half-sphere of direction lines appears. Click a line and the run continues that way, with the elbow or bend added for you. Click anywhere along a run instead and a full sphere appears, so you can branch off with a tee at that point.
How it works
1. Open a 3D view and click AG MEP 3D Router in the MEP panel on the Add-Ins tab.
2. Click a pipe, duct, conduit or cable tray. Click right at its open end to continue the run, or anywhere along it to branch off.
3. Direction lines appear at that point. At an open end, yellow goes straight on, red turns 45° and green turns 90°. Along a run, the green lines show where a tee can branch off.
4. Click a line, or click another piece of the same kind to head straight toward it. The new piece is drawn and connected with an elbow, bend or tee.
5. The new piece stays selected, so you can drag its end to the length you need. Run the tool again and click its free end to keep going.
Tip: give the command a keyboard shortcut (KS). Routing then becomes: shortcut, click the end, click a direction, drag to length, repeat.
Features
- Works with pipes, round and rectangular ducts, conduits and cable trays.
- Branch off with a tee anywhere along a run. You can branch every 45° around pipes, round ducts and conduits, off each face of rectangular ducts, and in the plane of a cable tray. A tee is only placed where it fits, with room to spare on both sides.
- Head straight at another piece. Click a piece of the same kind (pipe to pipe, duct to duct) and the new piece heads straight toward it, kept level, ready to connect.
- The new piece keeps the type, system, size, level and parameters of the piece you start from.
- Rectangular ducts and cable trays turn the way a real bend does. The cross-section stays square to the bend, and cable trays keep their open side facing the right way on vertical bends.
- Elbows, bends and tees come from your own setup: Routing Preferences for pipes and ducts, and the type's fittings for cable trays and conduits.
- Clicking straight on extends the same piece instead of adding a new one.
- Each step is a single Undo, and the direction lines are temporary, so nothing extra is left in your model.
Requirements
- Compatible with Revit 2020 to 2027.
- Works in 3D views of project files (not in the Family Editor).
- The direction lines are drawn as temporary model lines, so Lines must be visible in the 3D view. If a view template hides them, turn them on in the template.
- Each pipe, duct, conduit and cable tray type needs an elbow or bend, plus a tee for branches. Set them in Routing Preferences for pipes and ducts, or in the type's fittings for cable trays and conduits.
Details
Frequently asked questions (FAQs)
What else should I know about this product?
if you have any issue please contact with publisher Mail support: Elgendya33@gmail.com
Are there any known issues with this product?
The tool will only work with the hanger families attached to the Application
Is there additional support information provided?
if you have any issue please contact with publisher Mail support: Elgendya33@gmail.com
Found an issue?