Autodesk® Civil 3D® Pressure Network, plastics piping catalog to be used according to EN standards. All pipes are fully based on EN/ISO standards. Additional information has been attached to pipe properties if applicable according to the standard (PN, SDR, SN, Design Coefficient C, Minimum Required Strength, Material Class etc.). The manufacturer specific content is now divided into its own catalog (full version). Manufacturer-specific pipes are also divided according to EN/ISO standard, but product names are used according to the manufacturer's data sheets.

*Trial Catalog includes:

• all content of full catalog version (www.flowbim.ee) but limited to pipe diameter of DN 110 (if applicable)
  
  

*Full Catalog includes:

• Generic Content
• Manufacturer Specific Content

Generic Content includes:

• EN Plastic Pressure Pipes (EN 1555-2)
• EN Plastic Pressure Pipes (EN 12201-2)
• EN Plastic Pressure Pipes (EN 17176-2)
• EN Plastic Pressure Pipes (EN ISO 1452-2)

Manufacturer Specific Content includes:

• EN Plastic Pressure (water, sewerage) Pipes (Uponor, EN 12201-2)
• EN Plastic Pressure (gas) Electrofusion Fittings (Fusion Group, EN 1555-3)
• EN Plastic Pressure (water) Electrofusion Fittings (Fusion Group, EN 12201-3)
• EN Plastic Pressure Centric Reducers (Uponor, EN 12201-3)
• EN Plastic Pressure Segmented Fittings (Uponor, EN 12201-3)
• EN Plastic Pressure Stub Ends (Uponor, EN 12201-3)

Note: This catalog can be successfully used with any Hydraulics Calculations package, because pipes have their inner diameter value as well as outer pipe diameter. Pipe general diameter or any other property can be used in labels or taken over into Property Set Definitions.

Note: This app uses a custom installer (and not the standard App Store installer).